ErrorControl

This is used if the service fails to startup upon boot.

Value Meaning
0x00 If this driver can't be loaded or started ignore the problem and display no error
0x01 If the driver fails produce a warning but let bootup continue
0x02 Panic. If the current config is last known good continue, if not switch to last known good
0x03 Record the current startup as a failure. If this is last known good run diagnostic, if not switch to last known good and reboot
Start

This defines when in the boot sequence the service should be started. You can also set these by using the Services control panel applet.

Value Start Type Meaning
0x00 Boot The kernel loaded will load this driver first as its needed to use the boot volume device
0x01 System This is loaded by the I/O subsystem
0x02 Autoload The service is always loaded and run
0x03 Manual This service does not start automatically and must be manually started by the user
0x04 Disabled The service is disabled and should not be started
Type

This defines the kind of service or driver. They are loaded in the following order down the list.

Value Meaning
0x01 Kernel-mode device driver
0x02 Kernel-mode device driver that implements the file system
0x04 Information used by the Network Adapter
0x10 A Win32 service that should be run as a stand-alone process
0x20 A Win32 service that can share address space with other services of the same type

错误控制

如果服务在启动时无法启动，则使用此选项。

值 含义
0x00 如果无法加载或启动该驱动程序，请忽略该问题，并不显示任何错误
0x01 如果驱动程序失败，则会发出警告，但让启动继续
0x02 恐慌。如果当前配置是最近一次的正确，请继续，如果不是，请切换到最后一次的正确。
0x03 将当前启动记录为失败。如果这是最后一次正确的运行诊断，则如果未切换为最后一次正确的运行并重新启动
开始

这定义了在启动顺序中应何时启动服务。您也可以使用“服务”控制面板小程序来设置它们。

值 开始类型 含义
0x00 开机 加载的内核将根据需要使用启动卷设备首先加载该驱动程序
0x01 系统 由I / O子系统加载
0x02 自动加载 该服务始终加载并运行
0x03 手册 该服务不会自动启动，必须​​由用户手动启动
0x04 残障人士 该服务已禁用，不应启动
类型

这定义了服务或驱动程序的类型。它们按以下顺序从列表中向下加载。

值 含义
0x01 内核模式设备驱动程序
0x02 实现文件系统的内核模式设备驱动程序
0x04 网络适​​配器使用的信息
0x10 应作为独立进程运行的Win32服务
0x20 可以与相同类型的其他服务共享地址空间的Win32服务